Sensor Module

Sensor Module


The Sensor Module contains up to 4 universal inputs or outputs on a pluggable terminal block with support for a single-wire control bus. On the bus, you can connect various external sensors, such as digital, analog, or resistive, and communicate with other devices. More

Product code: 99.25.1429.8248

  • 5% discount when purchasing 10 or more pieces
  • 10% discount when purchasing 50 or more pieces

For orders of 200 pieces or more, contact us for an individual offer tailored to your needs.

Please note that discounts cannot be combined.


Free shipping on purchases over 120 EUR.

14,90 EUR excl. VAT (18,03 EUR incl. VAT)
In stock
pcs

The Sensor Module contains up to 4 universal inputs or outputs on a pluggable terminal block with support for a single-wire control bus. On the bus, you can connect various external sensors, such as digital, analog, or resistive, and communicate with other devices. More

Product code: 99.25.1429.8248

Two terminals—A on the left and B on the right—are connected to the HARDWARIO pins, P4/A4/DAC0 and P5/A5/DAC1 signals. In the basic configuration, Pin C is connected to GND ground. Resistor R20 can be removed and soldered in place of R21. C is connected to P7 and can be used as an extra input. The middle VCC pin can be controlled by software. This way, you can enable 3V on this pin.
 

Features

  • Operating voltage range: 1.65 V to 5.5 V
  • Operating temperature range: -20 to 70 °C
  • Dimensions: 33 x 55 mm
  • Configurable terminal modes:
    • Analog input or output
    • Digital input or output
    • Pull-up resistor none/4.7 kΩ/56 Ω
  • Interface examples:
    • Digital temperature sensor on single wire bus (DS18B20)
    • Resistive temperature sensor (Pt 100, Pt 1000, etc.)
    • Analog temperature sensor (LM35, TMP37, etc.)
    • NTC temperature sensor
    • Digital single-wire block relay control
    • Push button or any switch
    • Voltage measurement
  • Other features:
    • Plug-in 5-pin screw terminal block

Resources